LINEARWORKS CORPORATION

INSPECTION DIVISION

  • Home
  • About us
  • Services
    • PCB Design
    • PCB Inspection
  • News and Events
    • News and Events >
      • NEWS
      • EVENTS
    • Corporate Social Responsibility
  • AFFILIATES
  • Careers
  • Contact Us
  • PORTAL
AVI
Automated Visual Inspection
FVI
Final Visual Inspection
QAP
Quality Assurance Check
Picture
Plasma Cleaning
Laser Marking
Laser Marking
Washing
Ultrasonic Washing
Picture
Nitrogen Baking
Packaging
Automated Visual Inspection
Using high technology machine, printed circuit board is automatically inspected to detect non-conforming units with the use of high-definition camera connected to a computer to capture and process images and with the use of set standard for pattern measurement based on customer specification.




Final Visual Inspection
In Final Visual Inspection process, Printed Circuit Board is 100% inspected under stereoscopic microscopes with a magnification from 8-50x, by high-skilled inspectors mostly trained in Japan to ensure that all non-conforming units are identified and properly marked out to meet all quality requirements based on customer specifications and criteria.



Quality Assurance Check Process
In order to determine the compliance of product to the customer requirement and specification, Quality Assurance Department conducts sampling inspection and necessary checking to the product before delivery and ship out to the customer. Quality Assurance Department use acceptance criteria to evaluate the conformity of product to the standard.



Plasma Cleaning Process
A cleaning system process that involves the removal of impurities and contaminants from surfaces of the PCB through the use of an energetic plasma or dielectric barrier discharge (DBD) plasma created from gaseous species such as oxygen and argon. Once cleaning is done, wiring pattern's surface energy will increase also its adhesive characteristics which will make the wire bonding process more easier.


Laser Marking Process
By the use of eco-friendly Green Laser Marking Machine and Carbon Dioxide Technology, all detected non-conforming units of the PCB from AVI and FVI process were permanently marked using high powered laser with specific sizes, appearance and power ranges set according to customer requirement.





Ultrasonic Washing Process
A cleaning process that held product in between conveyorized net to ensure cleaning and removal of foreign materials from top to bottom of the PCB. It uses ultrasonic waves and de-ionized water as cleaning solvent to wash surfaces of the PCB and a high pressure blow of air to blow water after washing.




Nitrogen Baking Process
A process of PCB drying that uses a four-state programmable drying machine equipped with non-oxidizing gas that removes moisture on the substrate through a hermetically sealed chamber to decrease oxygen inside and to prevent ingress of external atmosphere



Product Packaging Process
The last process where products are carefully packed and sealed to ensure good condition before it departs from the company, during transportation and upon arrival to our customer. Proper labeling of products is observe for easy traceability.
 Site Map          Privacy Policy                                                                                                                                                   Copyright © 2010 - 2017 Linearworks Corporation. All Rights Reserved
  • Home
  • About us
  • Services
    • PCB Design
    • PCB Inspection
  • News and Events
    • News and Events >
      • NEWS
      • EVENTS
    • Corporate Social Responsibility
  • AFFILIATES
  • Careers
  • Contact Us
  • PORTAL